SUPPLIES & TOOLS:
DIRECTIONS:
- Silicone Letter Mold
- UV Resin
- Stir stick/toothpicks
- Assorted glitters
- Hand Drill
- Jump Rings
- Large Lobster Claw
- UV Light
DIRECTIONS:
- Open resin and slowly pour it into the desired letter mold. Fill up approximately half way.
- Add desired embellishments like different types of glitter. Swirl in to the resin using a stir stick or toothpick.
- Set the mold under the light and turn it on for 30-45 seconds. Add a small layer of resin to fill the entire mold. Adding this second layer will create a nice smooth surface. Put under the UV light until dried. Remove the letter from the mold once fully dried.
- Hand drill a small hold in the desired location on the letter.
- Put a jump ring in the hole.
- Attach a lobster claw to the jump ring and close the ring.