SUPPLIES & TOOLS:
- Heavy Chipboard (2.0mm)
- 12"x 48" Premium Permanent Vinyl, Pink
- 12"x 48" Premium Permanent Vinyl, Black
- 12"x 12" StrongGrip Machine Mat
- 12"x 12" StandardGrip Machine Mat
- 12"x 48" StandardGrip Vinyl Transfer Tape
- Knife Blade + Housing
- Weeder
- Scraper
- Masking Tape or Painter's Tape
- 3 Spray Paints in Assorted Colors
- Spray Primer
- Sealant (optional)
DIRECTIONS:
NOTE: Finished hangers are 11" wide.
PREPARATION
- To alter the project, use Preview panel to arrange pieces. Ensure pieces are within an 11"x 11" area, oriented to the top left corner of the mat.
- For best results, open chipboard and leave it out for 24 hours to acclimate. If the chipboard warps, place it under a heavy object. TIP: Increase project copies as desired.
- Use masking tape or painter’s tape to secure chipboard edges to mat.
- Follow Design Space prompts. Confirm correct cut setting and the Knife Blade.
- Carefully remove cut out hangars from mat and prep for painting by applying a few light coats of primer and allowing to dry completely.
- In a well-ventilated area and with appropriate protective gear, paint the hangers in the desired colors on all sides. Allow to dry completely.
- Use a Weeder Tool to remove unneeded vinyl pieces. When weeding, start from inside and move outward.
- Use tweezers and a Scraper Tool to apply vinyl cuts to the hangers. Make sure the surface is clean and dry.
- Seal with a spray or water-based sealer if desired.